| Other manufacturers | Other manufacturers No. | METROL No. |
|---|---|---|
OMRON |
D5A-B | H4A-08-02 |
| D5F-2B10 | H4A-53-01 | |
| D5F-2B30 | H4A-53-01 | |
| D5F-3C10 | H4A-53-02 | |
| D5F-3C30 | H4A-53-02 | |
| D5F-2B34C-Y | H4A-53-01 | |
| AZUMA | L4P01 | H4A-04-00 |
| E-SUNG | H4P-18-17-L | H4A-08-02 |
Tool setter Connection Procedure (Compatible with OMRON D5F)
 |
H4A-53 series This product is compatible with the D5F type of OMRON Corporation. Metrol supplies CNC sensors to the MAZAK Group in the same manner as OMRON Corporation. |
 |
[Disconnection] (1) First, find the sensor relay connector. It is located inside the arm or just behind the arm joint. |
 |
(2) Turn the fastening ring (  ) on the machine side counter-clockwise to remove it. |
 |
(3) Slowly pull the connectors straight apart. The connectors may be somewhat hard to disconnect. |
 |
[Connection](4) Compare the connector of the new sensor and the connector on the machine side and check that the pins and holes match. We recommend that you contact us so that we can arrange a refund for you if they do not match. *Please contact us after 30 days form the date of the purchase. |
 |
(5) After checking that the pins and holes are engaged, slowly push the connector straight in. |
 |
(6) Firmly turn in the clockwise direction to complete the connection procedure. *Failure to make a reliable connection can cause defective insulation between the cores, reduced accuracy due to shorting or defective signals. |
RSS Feeds
