 |
[Disconnection]
(1) First, find the sensor relay connector. It is located inside the arm
or just behind the arm joint. |
 |
(2) Slowly turn the locking ring ( )
in the counter-clockwise direction so that the small projection ( ) is positioned
vertically. |
 |
(3) Slowly pull the connectors apart while holding onto
the rough surface portions of the connectors. Then pull the locking ring
towards the back of the connector. (This allows you to make the subsequent
connection more reliably.) |
 |
[Connection]
(4) Compare the connector of the new sensor and the connector on the machine
side and check that the pins and holes match. (Contact us immediately
if they do not match.) Although the type shown here is of the 2-pin type,
4-pin and 5-pin types are also available. |
 |
(5) Slowly engage both connectors so that their colored
portions (previous illustration) are aligned. |
 |
(6) Next, push the connectors together so that the groove
of the locking ring aligns with the small projection, and then firmly turn
in the clockwise direction to complete the connection procedure.
(Failure to make a reliable connection can cause defective insulation between
the cores, reduced accuracy due to shorting or defective signals.)
|
